04 Laser Dotting Parameters Setting The emitting time (Page 72 / 76) RDWorks V8 Laser Engraving Cutting Software User Manual

Laser Engraving Cutting Software User Manual----RDCAM V8.0

4.10.4 Laser Dotting Parameters Setting

The emitting time for laser dot at one point the

process. The higher the value is, the darker the dot

is; if reverse, the weaker.

The interval between the dots

Draw dash line

Only dot in the center

4.11 Vendor parameters

4.11.1 Motor parameters

X/Y/Z/U-axis parameters

Direction Polarity: Direction polarity modification can move the motor to the opposite direction.

The modification purpose is to make the axis moving to the origin when resetting. If this axis

moves far from the origin on resetting, it means the direction polarity setting is wrong and should

be modified.

Spacing/limit Polarity: it is used to set the high and low level mode of spacing/limit signal. When

the motion axis arrives at the spacing/limit position and input a low-level signal to the controller,

the spacing/limit polarity should be set to negative at this time.

Breadth: The farthest distance of the axis moving, depending on the actual situation.

72 / 76